|
|
"Lieut_Data" <lIe### [at] yahOOcom> wrote in message
news:3cb0de83$1@news.povray.org...
> "Corey Woodworth" <cdw### [at] mpinetnet> wrote in message
> news:3cb0bd95@news.povray.org...
> > (ugh, I don't like making splines)
>
> Is that because you can't figure out where your control points / nodes
> should be?
not really. I just the route work. Its the boring part of POV to me.
And there is no preview short of low quality renders so It takes a lil
while to fix mistakes
> Would a visual tool that created 2D splines for use in lathes, sors,
prisms
> be helpful? I am in the progress of playing around with such a tool,
written
> in VB, but am not sure if there would be much interest besides my own
sense
> of accomplishment.
That'd be awesome. I'm use to dealing with bezier curves in PS. If it could
speed up the process of making them!
> Cheers!
>
> Lieut_Data
Corey
Post a reply to this message
|
|